The automatic assembly line equipment is designed and decided to adopt the minimum maintenance method. There are no parts on the equipment that move repeatedly, or only move when required by operation. This results in very little wear on the mechanical parts. The rest of the maintenance work is just simple cleaning or inspection.

cleaning job

Cleaning of equipment should be done at the usual maintenance intervals for the entire bottling line. Weekly cleaning is recommended, with detailed intervals depending on the level of contamination.

Usually, use a damp cloth or soft brush for cleaning. All parts are protected from water droplets or splashing water, but are not resistant to water jets. Especially very fine moisture can cause damage to the electronic system.

If moisture seeps into the device, turn it off and allow its parts to dry completely before turning it on again.

checking work

Inspection work refers to regular maintenance according to predetermined steps, and it is necessary to check (equipment) for deficiencies or defects in a timely manner. It is recommended to conduct an inspection once a month, and the inspection interval can be determined according to the workload of the equipment.

maintenance work

Repairs are necessary when parts are functional or have commensurate wear. Only professionals trained in responsive technology may perform necessary maintenance work. In order to ensure the long-term operation of the equipment, the original parts of the company should be used.