Automatic production lines save a lot of time and cost. In industrially developed cities, the maintenance of automatic production lines has become a hot spot. Automatic production line maintenance is mainly completed by operators and maintenance workers.

Two major methods of automatic production line maintenance:

Simultaneous repair method: During production, if a fault is found, try not to repair it, and take a maintenance method. Make the production line continue production until the holidays, and concentrate maintenance workers and operators to repair all problems at the same time. The equipment was in full-line production as normal on Monday.

Partial repair method: If there is a big problem in the automatic production line, the repair time is more frequent. Simultaneous repair method cannot be used. At this time, use the holidays to concentrate maintenance workers and operators to repair a certain part. Wait until next holiday to fix the other part. Ensure that the automatic production line does not stop production during working hours. In addition, try to use the pre-training method in management. Install a timer in the equipment, record the working time of the equipment, apply the wear law to predict the wear of the wearing parts, and replace the wearing parts in advance to eliminate the fault in advance. Ensure that the production line is at full capacity.

maintainance

Maintenance of automatic production line:

Electric circuits, gas circuits, oil circuits and mechanical transmission parts (such as guide rails, etc.) should be inspected and cleaned before and after work; inspections should be carried out during the work process, and key parts should be sampled. Any abnormality should be recorded, and minor problems should be handled before and after work (time not long), prepare spare parts for major problems; unify the entire line for maintenance, make a plan for wearing parts, and replace the wearing parts in advance to prevent problems from unburned.